Rigid Inflatable Boats : RIBS and Inflatables
 
HOME  •  RIBS4SALE  •  TRADE INDEX  •  FORUMS  •  CHANDLERY
polymarine inflatable boat products
[ article ]
  # 063
Fitting New Valves - Hypalon
more pages
 

Valve

 





Hypalon Tube Fabric



 

Materials needed:-
Valve (s)
Valve spanner
Doubler
P510 hypalon solvent
2990 two part adhesive
Hypalon material
Replacement valve(s)
Paint brush (cut down to 20-25mm bristle.)
Lint free cloth
Polythenne
Masking tape
Hair drier or a hot air gun
Knife handle or rounded piece of hardwood

IMPORTANT:
Before you start any glueing please note:- your workplace needs to be well ventilated, warm and dry. If the air is humid don't try to use the adhesive as it will bloom. Do not use a gas fire or naked flame heat source as the solvents are highly flammable. Do not use the adhesive if it has been mixed for more than 4 hours.

1. Take out your old valve. If the valve is glued on then heat the area with a hair drier or a hot air gun. This softens the adhesive and allows you to lift the edge and peel the valve back. The old adhesive will need to be sanded off. Check that the valve body will fit through the hole, if not make the hole bigger. If the valve is screwed together, unscrew and the back of the valve will be left inside the tube. To get this out make the hole bigger.

2. Prepare the outside of the tube. Place the doubler in position and mark around it with a pencil. Using the masking tape, tape around the patch leaving about a 3mm gap to allow for stretch on the material. Sand down the surface on the tube. The top surface needs to be sanded to a matt finish, the doubler is ready sanded. Wipe the surface of the patch and the tube that is going to have the adhesive on with the P510 solvent. Allow the solvent to flash off. If you apply the adhesive too soon it will bloom (turn slightly white) the adhesive will need to be removed and new adhesive will have to be applied.

3. Mix enough adhesive as directed on the tin. Brush onto the surface thinly, the surface should look wet. Allow the adhesive to dry for at least 30 minutes.

4. Brush on a second coat on both surfaces. Lay a piece of polythene onto the tube adhesive. Put the cage of the valve into the tube and push to one side. Place the doubler into position making sure that the valve will sit squarely on the doubler, remove polythene. Work one side down with your knife handle, pressing hard. Then work the other side. Work from the middle to the outside of the patch. You must make sure that there is no air trapped between the surfaces. Take off tape and clean off any adhesive. The adhesive will turn brown if left on the surface.

If you are putting a valve into a RIB, assemble the valve with the doubler. Place into the hole and rub the fabric down. You will need to use your hand from the outside of the tube to support the fabris, so you can rub down hard enough

5. Leave to dry for at least six hours.

6. When dry pump up the chamber. Tighten the valve, it should be tightened to a max of 10lbs which is hand tight and just pinched up. Check for air leaks

Acknowlegement:
Information courtesy of Polymarine, supplier of inflatable boat spares and accessories, visit: www.polymarine.com

June 2007

more pages

 



Rigid Inflatable Boats : RIBS and Inflatables
 
polymarine inflatable boat products
 
HOME  •  RIBS4SALE  •  TRADE INDEX  •  FORUMS  •  CHANDLERY